Our 7 bar gates are heavily constructed and galvanised. We stock gates with vertical not diagonal braces in order to avoid hoof damage and animals getting trapped. The gates have integral rather than tack welded braces and strengthened holes for the gate eyes. The gates come with a spring loaded sliding bolt assembly and 2 gate eyes.

Galvanised half mesh gates are very useful particularly during lambing. The gates are heavily galvanised and the mesh provides extra strength. They gates come with spring loaded sliding bolt assembly and 2 gate eyes.

1.24m wide, 1.15m in height Full Mesh gate

We have the 12ft Full mesh der gate in stock. The 4ft and 10ft may need to be ordered in.

The galvanised sheep hurdles are particularly useful during lambing or for sheep handling. Portable, strong and lightweight, these hurdles have a simple design and will last for years, the 2nd photo with Andrew in are the 4ft hurdles.

These 4.5inch diameter gate posts will take the weight of a 15ft gate if necessary. The posts are heavily made and heavily galvanised, they will not sag or bend as thinner or lighter posts do.

This galvanised gate hook has a 19mm diameter pin and it is suitable for most metal gates and the larger sizes of wooden gates. The angle of the hook through the gate post can be adjusted using the back screw to lift a sagging gate slightly.

This galvanised gate hook has a 19mm diameter pin and is used as a bottom hook for hanging gates, it is weight bearing.

This galvanised hook has a 19mm diameter pin and is used set in concrete in walls.

This galvanised 19mm hook has 4 screw holes in the plate so that it can be screwed onto walls or posts

This 13mm diameter galvanised hook is mostly used as an adjustable top hook for smaller wooden gates.

This 13mm diameter galvanised hook is used as a bottom hook for smaller wooden gates.

These are ungalvanised to fit them for welding

These are ungalvanised to fit them for welding

These are ungalvanised to fit them for welding

These are all suited to 19mm hooks, the size given is the length of shaft.

The farmers friend because it allows him to open a gate one handed and slam it behind him, also ideal for high traffic gates as it is very easy to use.

the archetypal farm gate closure.

this is used for metal gate pairs and it is necessary to drill a hole in the gate frame in order to fit it, ideally it should be used with a drop bolt. Health and Safety note, this design has been criticised because it could drop on a hand or arm.

this sliding gate frame joins two gates and cannot fall on anyones hand or arm although it could slide into them so is regarded as safer. It is also much heavier and puts considerable strain on the gate hinges.

Heavy Hasp and Staple

This drop bolt is used to stabilise a closed pair of gates or to hold a gate in a particular position, although strong it will not hold for more than a few years on it's own in a windy situation.

This drop bolt is used to stabilise a closed pair of gates or to hold a gate in a particular position.

galvanised, heavy duty and very easy to use.